Tektronix MSO58

Commands listed in alphabetical order
Syntax
POWer:POWer<x
>:POWERQUALITY:VSOURce
{CH<x> | MATH<x> | REF<x>}
POWer:POWer<x>:POWERQUALIT Y:VSOURce?
Arguments
CH<x> = A channel specifier; <x> is 1 through 8 and is limited by the number
of FlexChannels in your instrument.
MATH<x> = A math waveform specifier; <x> is ≥1.
REF<x> = A reference waveform specifier; <x> is ≥1.
Examples
POWer:POWer1:POWERQUALITY: VSOURce CH1 sets the voltage source for
power quality measurement as channel 1.
POWer:POWer<x>:PPULSEWIDTH:INPUTSOurce
This command sets or queries the input source for positive pulse width
measurement in the specified power measurement badge. The power measurement
badge is specified by x.
Conditions
Requires option 5-PWR, SUP5-PWR, or 5-PS2.
Group
Power
Syntax
POWer:POWer<x>:PPULSEWIDTH :INPUTSOurce {CH<x> | MATH<x> |
REF<x>}
POWer:POWer<x>:PPULSEWIDTH :INPUTSOurce?
Arguments
CH<x> = A channel specifier; <x> is 1 through 8 and is limited by the number
of FlexChannels in your instrument.
MATH<x> = A math waveform specifier; <x> is ≥1.
REF<x> = A reference waveform specifier; <x> is ≥1.
Examples
POWer:POWer1:PPULSEWIDTH:I NPUTSOurce CH5 sets channel 5 as the input
source for the positive pulse width measurement.
POWer:POWer<x>:REFLevel
s:ABSolute:FA LLHigh
This command sets or queries the falling edge for high reference level in absolute
units for the specified power measurement badge. The power measurement badge
is specified by x.
MSO54, MSO56, MSO58, MSO58LP Programmer 2-551