To Next Page

To Previous Page

Commands listed in alphabetical order

Arguments

FALL speciﬁes p

olarity as the clock falling edge.

RISe speciﬁes polarity as the clock rising edge.

Examples

TRIGger:A:SETHold:CLOCk:ED GE RISE speciﬁes the polarity as the clock

rising edge.

TRIGger:A:SETHold:CLOCk:ED GE? might return

:TRIGGER:A:SETHOLD:CLOCK:E DGE RISE indicating that polarity is speciﬁed

as the clock rising edge.

TRIGger:{A|B}:SETHold:CLOCk:SOUrce

This command speciﬁes the clock source for the setup and hold triggering. You

cannot specify the same source for both clock and data.

Group

Trigger

Syntax

TRIGger:{A|B}:SETHold:CLOC k:SOUrce {CH<x>|CH<x>_D<y >}

TRIGger:{A|B}:SETHold:CLOC k:SOUrce?

Arguments

CH<x> speciﬁes the analog channel to use as the clock source waveform.

CH<x>_D<y> speciﬁes the digital channel to use as the clock source waveform.

Examples

TRIGger:A:SETHold:CLOCk:SO Urce CH1 speciﬁes channel 1 as the clock

source for a setup and hold trigger operation.

TRIGger:A:SETHold:CLOCk:SO Urce? might return

:TRIGGER:A:SETHOLD:CLOCK:S OURCE CH4 indicating that channel

4 is the clock source for a setup and hold trigger o peration.

TRIGger:{A|B}:SETHold:HOLDTime

This command speciﬁes the hold time for setup and hold violation triggering.

This command is equivalent to selecting Setup/Hold Setup from the Trig menu

and then setting the desired Hold Time.

Group

Trigger

MSO54, MSO56, MSO58, MSO58LP Programmer 2-863

Tektronix MSO58 User Manual

Other manuals for Tektronix MSO58