Tektronix MSO58

Commands listed in alphabetical order
Group
Trigger
Syntax
TRIGger:{A|B}:BUS:B<x>:FLE Xray:DATa:OFFSet <NR1>
TRIGger:{A|B}:BUS:B<x>:FLE Xray:DATa:OFFSet?
Arguments
<NR1> is the offset of the data string in bytes. A byte offset of -1 signifies “d
on't
care”,andnobyteoffsetisused. Theinstrument will trigger on or match any
byte value that fits.
Examples
TRIGGER:A:BUS:B1:FLEXRAY:D ATA:OFFSET 1 sets the offset to 1.
TRIGGER:A:BUS:B1:FLEXRAY:D ATA:OFFSET? might return
TRIGGER:A:BUS:B1:FLEXRAY:D ATA:OFFSET 0 indicating that a data offset
of 0.
TRIGger:{A|B}:BUS:B<x>:FLEXray:DATa:QUALifier
This command specifies the qualifier(<,>,=,<=,>=,not=,inrange,
out of range) to use when triggering on the FlexRay bus data field.
The trigger condition needs to be set to ID or IDANDDATA (using
TRIGger:{A|B}:BUS:B<x>:FLEXray:CONDition). The bus number is specified
by <x>.
Conditions
Requires the SR-AUTO Triggering and Analysis application.
Group
Trigger
Syntax
TRIGger:{A|B}:BUS:B<x>:FLE Xray:DATa:QUALifier
{LESSthan|MOREthan|EQual|U NEQual|LESSEQual|MOREEQual|
INrange|OUTrange}
TRIGger:{A|B}:BUS:B<x>:FLE Xray:DATa:QUALifier?
Arguments
LESSthan sets the data qualifier to less than.
MOREthan sets the data qualifier to greater than.
EQual sets the data qualifier to eqaual.
UNEQual sets the data qualifier to not equal.
LESSEQual sets the data qualifier to less than or equal.
MOREEQual sets the data qualifier to greater than or equal.
MSO54, MSO56, MSO58, MSO58LP Programmer 2-797