To Next Page

To Previous Page

Commands listed in alphabetical order

MEASUrement:

MEAS<x>:EDGES:N

The command sets or queries the number of accumulation cycles for the

measurement when the measurement type is nperiod. Measurements are speciﬁed

by x.

Group

Measurement

Syntax

MEASUrement:MEAS<x>:EDGES: N <NR3>

MEASUrement:MEAS<x>:EDGES: N?

Arguments

<NR3> is the maximum number of edges used by the measurement.

Examples

measurement:meas1:edges:n 2 sets the number of edges to 2.

measurement:meas1:edges:n? might return

:MEASUREMENT:MEAS1:EDGES:N 6.0000.

MEASUrement:MEAS<x>:EDGES:SLEWRATEMethod

This command sets or queries the slew rate method for the measurement.

Measurements are speciﬁed by x.

Group

Measurement

Syntax

MEASUrement:MEAS<x>:EDGES: SLEWRATEMethod {NOMinal|DDR}

MEASUrement:MEAS<x>:EDGES: SLEWRATEMethod?

Arguments

NOMinal speciﬁes the nominal slew rate method.

DDR speciﬁes the DDR sle w rate method.

Examples

measurement:meas1:edges:sl ewratemethod NOMINAL speciﬁes the

nominal slew rate method.

measurement:meas1:edges:sl ewratemethod? might return

:MEASUREMENT:MEAS1:EDGES:S LEWRATEMETHOD NOMINAL indicating the

slew rate method is set to NOMINAL.

MSO54, MSO56, MSO58, MSO58LP Programmer 2-445

Tektronix MSO58 User Manual

Other manuals for Tektronix MSO58