Tektronix MSO58 - SEARCH:SEARCH<x>:TRIGger:A:BUS:USB:SPLIT:PORT:VALue; SEARCH:SEARCH<x>:TRIGger:A:BUS:USB:SPLIT:SC:VALue

Commands listed in alphabetical order
SEARCH:SEARC
H<x>:TRIGger:A:BUS:USB:SPLIT:PORT:VALue
This co mmand sets or queries the binary port address used when searching on a
USB bus signal. The search number is specified by <x>. The search c ondition
must be set to
Special with a packet type SPLIT.
Conditions
Requires the SR-USB2 Serial Triggering and Analysis Application.
Group
Search and Mark
Syntax
SEARCH:SEARCH<x>:TRIGger:A :BUS:USB:SPLIT:PORT:VALue
<QString>
SEARCH:SEARCH<x>:TRIGger:A :BUS:USB:SPLIT:PORT:VALue?
Arguments
<QString> specifies the port address in the valid format. The valid characters are
Examples
SEARCH:SEARCH1:TRIGGER:A:B US:USB:SPLIT:PORT:VALUE " 1111" sets
the port address for USB bus trigger search 1 to "XXX1111" for binary format.
SEARCH:SEARCH1:TRIGGER:A:B US:USB:SPLIT:PORT:VALUE? might
return
SEARCH:SEARCH1:TRIGGER:A:BU S:USB:SPLIT:PORT:VALUE "X X",
indicating that the port address for USB hub trigger search 1 is set to "XX"
in hexadecimal format.
SEARCH:SEARCH<x>:TRIGger:A:BUS:USB:SPLIT:SC:VALue
This command sets or queries the Start/Complete value for the specified USB bus
trigger on split token field search to determine where to place a mark. The search
number is specified by <x>.
Conditions
Requires the SR-USB2 Serial Triggering and Analysis Application.
Group
Search and Mark
Syntax
SEARCH:SEARCH<x>:TRIGger:A :BUS:USB:SPLIT:SC:VALue
{CSPLIT|NOCARE|SSPLIT}
SEARCH:SEARCH<x>:TRIGger:A :BUS:USB:SPLIT:SC:VALue?
Arguments
CSPLIT specifies Complete (CSPLIT)(1) Start/Complete value.
NOCARE specifies the Start
/Complete value as Don’t Care (X).
MSO54, MSO56, MSO58, MSO58LP Programmer 2-711