To Next Page

To Previous Page

Commands listed in alphabetical order

Group

Measurement

Syntax

MEASUrement:REFLevels:JITT ERMODE {CONTinuous|LATCh}

MEASUrement:REFLevels:JITT ERMODE?

Arguments

CONTinuous speciﬁes that reference levels are calculated on every acquisition.

LATCh speciﬁes that reference levels are calculated only on the ﬁrst acquisition

after a statistics reset.

Examples

MEASUREMENT:REFLEVELS:JITT ERMODE CONTINUOUS speciﬁes that reference

levels are c alculated on every acquisition.

MEASUREMENT:REFLEVELS:JITT ERMODE? might return LATCH indicating that

reference levels are calculated only on the ﬁrst acquisition after a statistics reset.

MEASUrement:REFLevels:METHod

This command sets or queries the method used to calculate reference levels for

the measurement.

Group

Measurement

Syntax

MEASUrement:REFLevels:METH od {PERCent|ABSolute}

MEASUrement:REFLevels:METH od?

Arguments

PERCent speciﬁes that the reference levels are calculated as a percent

relative to HIGH and LOW. The percentages are deﬁned using the

MEASUrement:REFLevels:REFL evel:PERCent commands.

ABSolute speciﬁes that the reference levels are set explicitly using the

MEASUrement:REFLevels:REFL evel:ABSolute commands. This method is

useful when precise values are required.

Examples

MEASUrement:REFLevels:METH od ABSOLUTE speciﬁes that the reference

levels are set explicitly.

MEASUrement:REFLevels:METH od? might return

:MEASUREMENT:REFLEVELS:MET HOD PERCENT indicating the reference levels

are calculated as a percent relative to HIGH and LOW.

MSO54, MSO56, MSO58, MSO58LP Programmer 2-501

Tektronix MSO58 User Manual

Other manuals for Tektronix MSO58