Tektronix MSO58

Commands listed in alphabetical order
Group
Bus
Syntax
BUS:B<x>:USB:SIGNALTYpe {SINGLE|DIFF}
BUS:B<x>:USB:SIGNALTYpe?
Arguments
SINGLE specifies single-ended signals.
DIFF specifies differential signals.
Examples
BUS:B1:USB:SIGNALTYpe SINGLE specifies single-ended signals.
BUS:B1:USB:SIGNALTYpe? might return : BUS:B1:USB:SIGNALTYPE DI FF
indicating the signal type is differential.
BUS:B<x>:USB:SOUrce
This command sets or queries th
e USB data source when the signal type is
differential for bus <x>. The bus number is specified by <x>.
Conditions
Requires option SR-USB2.
Group
Bus
Syntax
BUS:B<x>:USB:SOUrce {CH<x>|MATH<x>| REF<x>}
BUS:B<x>:USB:SOUrce?
Related Commands
BUS:B<x>:USB:SOUrce:DMINus, BUS:B<x>:USB:SOUrce:DPLUs
Arguments
CH<x> specifies an analog channel as the data source for the specified USB bus.
MATH<x> specifies a math channel as the data source for the specified USB bus.
REF<x> specifies a reference waveform as the data source.
Examples
BUS:B1:USB:SOURCE D2 sets the USB data source for bus B1 to D2.
BUS:B1:USB:SOURCE? might return :BUS:B1:USB:SOURCE D3, indicating that
the USB data source for bus B1 is D3.
2-180 MSO54, MSO56, MSO58, MSO58LP Programmer