Tektronix MSO58

Commands listed in alphabetical order
SEARCH:SEARC
H<x>:TRIGger:A:BUS:I2C:ADDRess:MODe
This command sets or queries the I2C address mode for the specified bus search to
determine where to place a mark. The search number is specified by <x>.
Conditions
Requires the SR-EMBD Triggering and Analysis application.
Group
Search and Mark
Syntax
SEARCH:SEARCH<x>:TRIGger: A:BUS:I2C:ADDRess:MODe
{ADDR10|ADDR7}
SEARCH:SEARCH<x>:TRIGger: A:BUS:I2C:ADDRess:MODe?
Arguments
ADDR10 specifies the address mode as ADDR10.
ADDR7 specifies the address mode as ADDR7.
Examples
SEARCH:SEARCH1:TRIGGER:A: BUS:I2C:ADDRESS:MODE ADDR 10 sets the
address mode for I2C bus trigger search 1 to ADDR10.
SEARCH:SEARCH2:TRIGGER:A: BUS:I2C:ADDRESS:MODE? might return
:SEARCH:SEARCH2:TRIGGER:A :BUS:I2C:ADDRESS:MODE ADD R7, indicating
that the address mode for I2C bus trigger search 2 is set to ADDR7.
SEARCH:SEARCH<x>:TRIGger:A:BUS:I2C:ADDRess:VALue
This command sets or queries the binary address s tring used for the I2C search
the speci fied search condition is Address or AddressData. The search number is
specified by <x>.
Conditions
Requires the SR-EMBD Triggering and Analysis application.
Group
Search and Mark
Syntax
SEARCH:SEARCH<x>:TRIGger: A:BUS:I2C:ADDRess:VALue < QString>
SEARCH:SEARCH<x>:TRIGger: A:BUS:I2C:ADDRess:VALue?
Related Commands
SEARCH:SEARCH<x>:TRIGger:A:BUS:I2C:ADDRess:MODe
2-674 MSO54, MSO56, MSO58, MSO58LP Programmer