Tektronix MSO58 User Manual

Commands listed in alphabetical order
TRIGger:{A|B
}:BUS:B<x>:FLEXray:CYCLEcount:HIVALue
This command specifies the high value when triggering on a FlexRay bus cycle
count field. (Use TRIGger:{A|B}:BUS:B<x>:FLEXray:CYCLEcount:VALue to
set the low va
lue.) The trigger condition must be set to CYCLEcount (using
TRIGger:{A|B}:BUS:B<x>:FLEXray:CONDition). The bus number is specified
by <x>.
Conditions
Requires the SR-AUTO Triggering and Analysis application.
Group
Trigger
Syntax
TRIGger:{A|B}:BUS:B<x>:FL EXray:CYCLEcount:HIVALue <QString>
TRIGger:{A|B}:BUS:B<x>:FL EXray:CYCLEcount:HIVALue?
Arguments
<QString> isaquotedstringthatisthecyclecounthighvalue.
Examples
TRIGGER:A:BUS:B1:FLEXRAY: CYCLECOUNT:HIVALUE "11001 0" sets the
cycle count high value to 110010.
TRIGGER:A:BUS:B1:FLEXRAY: CYCLECOUNT:HIVALUE? might return
TRIGGER:A:BUS:B1:FLEXRAY: CYCLECOUNT:HIVALUE "XXXXX X" indicating
the cycle count high value is don't care.
TRIGger:{A|B}:BUS:B<x>:FLEXray:CYCLEcount:QUALifier
This command specifies the qualifier(<,>,=,<=,>=,not=,in
range, out of range) to use when triggering on the FlexRay bus cycle
count field. The trigger condition must be set to CYCLEcount (using
TRIGger:{A|B}:BUS:B<x>:FLEXray:CONDition).The bus number is specified
by <x>.
Conditions
Requires the SR-AUTO Triggering and Analysis application.
Group
Trigger
Syntax
TRIGger:{A|B}:BUS:B<x>:FL EXray:CYCLEcount:QUALifier
{LESSthan|MOREthan|EQual| UNEQual|LESSEQual|MOREEQual|
INrange|OUTrange}
TRIGger:{A|B}:BUS:B<x>:FL EXray:CYCLEcount:QUALifier?
2-794 MSO54, MSO56, MSO58, MSO58LP Programmer

Tektronix MSO58 Specifications

General

Brand	Tektronix
Model	MSO58
Category	Test Equipment
Language	English