To Next Page

To Previous Page

Commands listed in alphabetical order

Related Commands

TRIGger:{A|B}

:BUS:B<x>:ETHERnet:CONDition

TRIGger:{A|B}:BUS:B<x>:ETHERnet:IPHeader:SOUrceaddr:VALue

TRIGger:{A|B}:BUS:B<x>:ETHERnet:IPHeader:DESTinationaddr:VALue

Arguments

<QString> is a quoted string of up to 8 characters where the allowable characters

are0,1,andX.Thebitsspeciﬁed in the quoted string replace the least signiﬁcant

bits, leaving any unspeciﬁed upper bits unchanged.

Examples

TRIGGER:A:BUS:B1:ETHERNET: IPHEADER:PROTOCOL:VALUE "01010010"

would set the value to be used in the trigger to 01010010.

TRIGger:A:BUS:B1:ETHERnet: IPHeader:PROTOcol:VALue? might return

"XXXXXXXX".

TRIGger:{A|B}:BUS:B<x>:ETHERnet:IPHeader:SOUrceaddr:VA Lue

When the Ethernet trigger condition is set to IPHeader , this command speciﬁes

the value of the 32-bit source address that is to be used in the trigger (along with

the destination address and protocol value). The IP source address is a standard

IP address such as 192.168.0.1. The default is all X’s (don’t care). The bus

number is speciﬁed by <x>.

Conditions

Requires the SR-ENET Triggering and Analysis application.

Group

Trigger

Syntax

TRIGger:{A|B}:BUS:B<x>:ETH ERnet:IPHeader:

SOUrceaddr:VALue

TRIGger:{A|B}:BUS:B<x>:ETH ERnet:IPHeader:SOUrceaddr:VALue?

Related Commands

TRIGger:{A|B}:BUS:B<x>:ETHERnet:CONDition

TRIGger:{A|B}:BUS:B<x>:ETHERnet:IPHeader:DESTinationaddr:VALue

TRIGger:{A|B}:BUS:B<x>:ETHERnet:IPHeader:PROTOcol:VALue

Arguments

<QString> is a quoted string of up to 32 characters where the allowable

characters are 0, 1, and X. The bits speciﬁed in the quoted string replace the least

signiﬁcant bits, leaving any unspeciﬁed upper bits unchanged.

MSO54, MSO56, MSO58, MSO58LP Programmer 2-785

Tektronix MSO58 User Manual

Other manuals for Tektronix MSO58