Tektronix MSO58

Commands listed in alphabetical order
Conditions
Requires the SR
-AUTO Triggering and Analysis application.
Group
Search and Mark
Syntax
SEARCH:SEARCH<x>:TRIGger: A:BUS:CAN:DATa:QUALifier
{EQUal|LESSEQual|MOREEQua |UNEQual|LESSthan|MOREthan}
SEARCH:SEARCH<x>:TRIGger: A:BUS:CAN:DATa:QUALifier?
Arguments
Argumentsarethedataqualifier types.
Examples
SEARCH:SEARCH1:TRIGger:A: BUS:CAN:DATa:QUALifier UN EQual sets
thedataqualifier to unequal.
SEARCH:SEARCH1:TRIGger:A: BUS:CAN:DATa:QUALifier? might return
:SEARCH:SEARCH1:TRIGGER:A :BUS:CAN:DATA:QUALIFIER E QUAL,
indicating that the data qualifier is set to equal.
SEARCH:SEARCH<x>:TRIGger:A:BUS:CAN:DATa:SIZe
This command sets or queries the length of the data string, in bytes, to be used
when searching on a CAN bus signal. The search condition must be set to
IDANDDATA or DATA. The search number is specified by <x>.
Conditions
Requires the SR-AUTO Triggering and Analysis application.
Group
Search and Mark
Syntax
SEARCH:SEARCH<x>:TRIGger: A:BUS:CAN:DATa:SIZe <NR1>
SEARCH:SEARCH<x>:TRIGger: A:BUS:CAN:DATa:SIZe?
Arguments
<NR1> specifies the data size.
Examples
SEARCH:SEARCH1:TRIGger:A: BUS:CAN:DATa:SIZe 1 sets the data size to 1.
SEARCH:SEARCH1:TRIGger:A: BUS:CAN:DATa:SIZe? might return
:SEARCH:SEARCH1:TRIGGER:A :BUS:CAN:DATA:SIZE 1, indicating the data
size is set to 1.
2-644 MSO54, MSO56, MSO58, MSO58LP Programmer