Tektronix MSO58

Commands listed in alphabetical order
DONTINCLUDE in
dicating the specified reference SETHOLD inputs will not be
included in the specified search.
SEARCH:SEARCH<x>:TRIGger:A:SETHold:SETTime
This command sets or queries the setup time setting for a setup/hold trigger search
to determine where to place a mark. The search number is specified by <x>.
Group
Search and Mark
Syntax
SEARCH:SEARCH<x>:TRIGger:A :SETHold:SETTime <NR3>
SEARCH:SEARCH<x>:TRIGger:A :SETHold:SETTime?
Arguments
<NR3> specifies the setup time for setup and hold violation triggering.
Examples
SEARCH:SEARCH1:TRIGGER:A:S ETHOLD:SETTIME 2E–9 sets the setup/hold
trigger setup time setting for search 1 to 2 ns.
SEARCH:SEARCH1:TRIGGER:A:S ETHOLD:SETTIME? might return
:SEARCH:SEARCH1:TRIGGER:A: SETHOLD:SETTIME 1.0000E–9, indicating
that the setup/hold trigger setup time setting for search 1 is set to 1.0 ns.
SEARCH:SEARCH<x>:TRIGger:A:STATE
This command sets or queries the enabled state of the search. The search number
is specified by <x>.
Group
Search and Mark
Syntax
SEARCH:SEARCH<x>:TRIGger:A :STATE {<NR1>|OFF|ON}
Arguments
<NR1> = 1 enables the search. Any other character disabl
es the search.
ON enables the search.
OFF disables the search.
Examples
SEARCH:SEARCH1:TRIGger:A:S TATE OFF disables the search.
SEARCH:SEARCH1:TRIGger:A:S TATE? might return
:SEARCH:SEARCH1:TRIGGER:A: STATE 1 indicating search 1 is enabled.
MSO54, MSO56, MSO58, MSO58LP Programmer 2-737