Tektronix MSO58

Commands listed in alphabetical order
Syntax
SEARCH:SEARCH
<x>:TRIGger:A:BUS:FLEXRAY:DA Ta:SIZe <NR1>
SEARCH:SEARCH<x>:TRIGger:A :BUS:FLEXRAY:DATa:SIZe?
Arguments
<NR1> specifies the data size in bytes. A data size of –1 is don’t care.
Examples
SEARCH:SEARCH1:TRIGger:A:B US:FLEXRAY:DATa:SIZe 2 sets the data
size to 2.
SEARCH:SEARCH1:TRIGger:A:B US:FLEXRAY:DATa:SIZe? might return
:SEARCH:SEARCH1:TRIGGER:A: BUS:FLEXRAY:DATA:SIZE 1, indicating
thedatasizeis1byte.
SEARCH:SEARCH<x>:TRIGger:A:BUS:FLEXRAY:DATa:VALue
This command sets or queries the low value to be used when searching on a
FlexRay bus data field. The search number is specified by <x>. The search
condition must be set to IDANDDATA or DATA.
Conditions
Requires the SR-AUTO Triggering and Analysis application.
Group
Search and Mark
Syntax
SEARCH:SEARCH<x>:TRIGger:A :BUS:FLEXRAY:DATa:VALue < QString>
SEARCH:SEARCH<x>:TRIGger:A :BUS:FLEXRAY:DATa:VALue?
Arguments
<QString> specifiesthedatavalue.
Examples
SEARCH:SEARCH1:TRIGger:A:B US:FLEXRAY:DATa:VALue "10 10" sets the
data value to XXXXXX1010.
SEARCH:SEARCH1:TRIGger:A:B US:FLEXRAY:DATa:VALue? might
return
:SEARCH:SEARCH1:TRIGGER:A :BUS:FLEXRAY:DATA:VALUE
"XXXXXXXXXX"
, indicating the data value is a don’t care.
SEARCH:SEARCH<x>:TRIGger:A:BUS:FLEXRAY:EOFTYPE
This command sets or queries the end of frame type when searching on a FlexRay
bus signal. The search number is specified by <x>. The search condition
must
be set to EOF.
MSO54, MSO56, MSO58, MSO58LP Programmer 2-667