Commands listed in alphabetical order
TRIGger:{A|B
}:BUS:B<x>:USB:SPLit:SC:VALue
When triggering on a high-speed USB split transaction, this command specifies
whether to trigger on the start or complete phase of the split transaction, based
on the Start/
Complete bit field value. (0 = Start, 1 = Complete). The d efault is
NOCARE. The bus number is specified by <x>.
Conditions
Requires t
he SR-USB2 Serial Triggering and Analysis Application.
Group
Trigger
Syntax
TRIGger:{A|B}:BUS:B<x>:US B:SPLit:SC:VALue
{NOCARE|SSPLIT|CSPLIT}
TRIGger:{A|B}:BUS:B<x>:US B:SPLit:SC:VALue?
Related Commands
TRIGger:{A|B}:BUS:B<x>:USB:SPECIALType
Arguments
NOCARE — trigger on either the start or complete phase of the split transaction.
SSPLIT — trigger on the start phase of the split transaction.
CSPLIT — trigger on the complete phase of the split transaction.
Examples
TRIGger:A:BUS:B1:USB:SPLi t:SC:VALue SSPLIT specifies to trigger on
the start phase of the split transaction.
TRIGger:A:BUS:B1:USB:SPLi t:SC:VALue? might indicate NOCARE,
specifying that it doesn’t matter whether to trigger on t he start or complete phase
of the split transaction.
TRIGger:{A|B}:BUS:B<x>:USB:SPLit:SE:VALue
When triggering on a high-speed USB split transaction, this command specifies
the split transa
ction start/end bit value to trigger on. The bus number is specified
by <x>.
2-846 MSO54, MSO56, MSO58, MSO58LP Programmer
To Next Page
Loading...
Need help?
General
