To Next Page

To Previous Page

Commands listed in alphabetical order

CH<x>:PRObe:

UNIts? (Query Only)

This query-only command returns a string describing the units of measure for the

probe attached to the speciﬁed channel. The channel is speciﬁed by x.

Group

Vertical

Syntax

CH<x>:PRObe:UNIts?

Related Commands

CH<x>:PROBEFunc:EXTUnits

Examples

CH4:PROBE:UNITS? might return :CH4:PROBE:UNITS "V", indicating that the

units of measure for the probe attached to Channel 4 are volts.

CH<x>:PROBECal? (Query Only)

This query-only command returns the probe c alibration state for the speciﬁed

channel. The channel is speciﬁed by x.

Group

Vertical

Syntax

CH<x>:PROBECal?

Returns

This query will return one of the following:

Failed signiﬁes that the probe calibration has failed for the selected channel.

Default signiﬁes that the p robe calibration has not yet been run for the

selected channel.

Passed signiﬁes the probe calibration h as passed for the selected channel.

Running signiﬁes the probe calibration is running.

Examples

CH2:PROBECAL? might return :CH2:PROBECAL PASSED indicating that the

probe calibration has passed for Channel 2.

CH<x>:PROBECOntrol

This command sets or queries multirange probe range-control policy preference of

the probe that is attached to CH<x>. The channel number is speciﬁed by <x>.

2-200 MSO54, MSO56, MSO58, MSO58LP Programmer

Tektronix MSO58 User Manual

Other manuals for Tektronix MSO58