To Next Page

To Previous Page

Commands listed in alphabetical order

Syntax

BUS:B<x>:LABe

l:XPOS <NR 3>

BUS:B<x>:LABel:XPOS?

Arguments

<NR3> is the x-position, in pixels relative to the left edge of the screen,, of the

speciﬁed bus label.

Examples

BUS:B1:LABel:XPOS 90 set the x position to 90.

BUS:B1:LABel:XPOS? might return :BUS:B1:LABEL:XPOS 45.0000

indicating the x position is 45.0 pixels to the right of the left edge of the display.

BUS:B<x>:LABel:YPOS

This command sets or q ueries the y -position o f the speciﬁed bus label. The bus

is speciﬁed by x.

Group

Bus

Syntax

BUS:B<x>:LABel:YPOS <NR3>

BUS:B<x>:LABel:YPOS?

Arguments

<NR3> is the y-position, in pixels relative to the baseline of the waveform, of

the speciﬁed bus label.

Examples

BUS:B1:LABel:YPOS 1.0e1 set the y position to 10.0.

BUS:B1:LABel:YPOS? might return :BUS:B1:LABEL:YPOS 0.0E+0

indicating the y position is 0.0 pixels from the baseline of the waveform.

BUS:B<x>:LIN:BITRate

This command sets or queries the LIN bus bit rate. The bus number is speciﬁed by

x. If you select Custom, use BUS:B<x>:LIN:BITRate:CUSTom to set the bit rate.

Conditions

Requires option SR-AUTO.

Group

Bus

Syntax

BUS:B<x>:LIN:BITRate

{RATE10K|RATE1K|RATE19K|RA TE2K|RATE4K|RATE9K|CUSTom}

MSO54, MSO56, MSO58, MSO58LP Programmer 2-151

Tektronix MSO58 User Manual

Other manuals for Tektronix MSO58