Tektronix MSO58 User Manual

Commands listed in alphabetical order
Group
Cursor
Syntax
DISplay:PLOTView<x>:CURSo r:SPLITMODE {SAME SPLIT}
DISplay:PLOTView<x>:CURSo r:SPLITMODE?
Arguments
SAME specifies that both cursors are on the same waveform.
SPLIT specifies that the cursors can b e on different waveforms.
Examples
DISplay:PLOTView1:CURSor: SPLITMODE SAME sets the cursors to be on the
same waveform.
DISplay:PLOTView1:CURSor: SPLITMODE? might return
:DISPLAY:PLOTVIEW1:CURSOR :SPLITMODE SAME indicating both
cursors are on the same waveform.
DISplay:PLOTView<x>:CURSor:STATE
This command sets or querie
s the visible state of the cursor of the specified cursor
in the specified view.
Group
Cursor
Syntax
DISplay:PLOTView<x>:CURSo r:STATE {OFF|ON|<NR1>}
DISplay:PLOTView<x>:CURSo r:STATE?
Arguments
OFF disables the specified cursor.
ON enables the specified cursor.
<NR1> = 0 disables the specified cursor; any other value enables the specified
cursor.
Examples
DISplay:PLOTView1:CURSor: STATE OFF disables the specified cursor.
DISplay:PLOTView5:CURSor: STATE? might return
:DISPLAY:PLOTVIEW5:CURSOR :STATE 1 indicating cursors are on.
DISplay:PLOTView<x>:CURSor:VBArs:APOSition
This command sets or queries the vertical cursor A position of the specified cursor
in the specified view.
2-256 MSO54, MSO56, MSO58, MSO58LP Programmer

Tektronix MSO58 Specifications

General

Analog Channels	8
Sample Rate	6.25 GS/s
Operating Temperature	0 °C to +50 °C
Bandwidth	2 GHz
Digital Channels	16
Record Length	125 Mpoints
Display	15.6 inch touchscreen
Waveform Update Rate	>500, 000 waveforms/s
Vertical Resolution	12 bits
Input Impedance	1 MΩ ±1%, 13 pF ±2 pF
Maximum Input Voltage	300 V (DC + AC peak)
Probe Interface	TekVPI
Dimensions	14.4 in x 8.7 in x 6.0 in