Tektronix MSO58

Commands listed in alphabetical order
SEARCH:SEARC
H<x>:TRIGger:A:BUS:FLEXRAY:DATa:HIVALue
This command sets or queries the high value when searching on a FlexRay bus
data field. The search number is specified by <x>. The search condition must be
set to IDANDD
ATA O R D ATA .
Conditions
Requires the SR-AUTO Triggering and Analysis application.
Group
Search and Mark
Syntax
SEARCH:SEARCH<x>:TRIGger:A :BUS
:FLEXRAY:DATa:HIVALue
<QString>
SEARCH:SEARCH<x>:TRIGger:A :BUS:FLEXRAY:DATa:HIVALue?
Arguments
<QString> specifiesthedatavalue.
Examples
SEARCH:SEARCH1:TRIGger:A:B US:FLEXRAY:DATa:HIVALue " 1010" sets
the data value to XXXXXX1010.
SEARCH:SEARCH1:TRIGger:A:B US:FLEXRAY:DATa:HIVALue? might
return
:SEARCH:SEARCH1:TRIGGER:A :BUS:FLEXRAY:DATA:HIVALUE
"XXXXXXXXXX"
, indicating the data value is a don’t care.
SEARCH:SEARCH<x>:TRIGger:A:BUS:FLEXRAY:DATa:OFFSet
This command sets or q ueries the offset of the data string, in bytes, when
searchingonaFlexRaybusdatafield. The search number is specified by <x>.
The search condition must be set to IDANDDATA OR DATA.
Conditions
Requires the SR-AUTO Triggering and Analysis application.
Group
Search and Mark
Syntax
SEARCH:SEARCH<x>:TRIGger:A :BUS:FLEXRAY:DATa:OFFSet <NR3>
SEARCH:SEARCH<x>:TRIGger:A :BUS:FLEXRAY:DATa:OFFSet?
Arguments
<NR3> specifies the data offset in bytes. A setting of X/Don’t care is accomplished
by setting the offset to –1.
MSO54, MSO56, MSO58, MSO58LP Programmer 2-665