Commands listed in alphabetical order
type. Some wave
forms are normalized vector data where the data points are
8-byte doubles in floating p oint format whereas other formats are 1-byte or 2-byte
integers.
Group
Waveform Transfer
Syntax
WFMOutpre:ASC_Fmt?
Related Commands
DATa:SOUrce, WFMOutpre:BN_Fmt, WFMOutpre:ENCdg
Returns
FP repres ents fl oating point ASCII data. The waveforms are normalized vector
data where the data points are 8-byte doubles in floating point format.
INTEGER represents signed integer ASCII data. The waveform data are 1-byte
or 2-byte integers.
Examples
WFMOutpre:ASC_Fmt? might return :WFMOUTPRE:ASC_FMT INTEGER
indicating the ASCII format is integer.
WFMOutpre:BIT_Nr
This command sets and queries the number of bits per waveform point that
outgoing waveforms contain, as specified by the DATa:SOUrce command. Note
that values will be constrained according to the underlying waveform data. This
specification is only meaningful when WFMOutpre:ENCdg is set to BIN and
WFMOutpre:BN_Fmt is set to either RI or RP.
Group
Waveform Transfer
Syntax
WFMOutpre:BIT_Nr <NR1>
WFMOutpre:BIT_Nr?
Related Commands
DATa:SOUrce, WFMOutpre:BN_Fmt, WFMOutpre:ENCdg
Arguments
<NR1> number of bits per data point can be 8 or 16.
Examples
WFMOUTPRE:BIT_NR 16 sets the number of bits per waveform point to 16 for
incoming RI and RP binary format data.
MSO54, MSO56, MSO58, MSO58LP Programmer 2-891
To Next Page
Loading...
Need help?
General
