Commands listed in alphabetical order
Examples
TRIGGER:A:BUS
:B1:MIL1553B:STATUS:ADDRESS: VALUE "X1000"
sets the
value to X1000.
TRIGGER:A:BU
S:B1:MIL1553B:STATUS:ADDRE SS:VALUE?
might return
"XXXXX", indicating that the value is XXXXX.
TRIGger:{A|B}:BUS:B<x>:MIL1553B:STATus:BIT:BCR
This command sets or queries the value of the broadcast command received bit
(BCR bit, bit 15) in a status word for a MIL-STD-1553 bus to triggering on. The
bus number is specified by x. The trigger condition must be set to STATus.
Conditions
Requires the SR-AERO Triggering and Analysis application.
Group
Trigger
Syntax
TRIGger:{A|B}:BUS:B<x>:MIL 1553B:STATus:BIT:BCR
{ONE|ZERo|NOCARE}
TRIGger:{A|B}:BUS:B<x>:MIL 1553B
:STATus:BIT:BCR?
Arguments
ONE filters status words to only match those where the BCR bit has a value of 1.
ZERo filters status words to only match those where th e BCR bit has a value of 0.
NOCARE disables filtering of status words on the BCR bit.
Examples
TRIGGER:A:BUS:B1:MIL1553B: STATUS:BIT:BCR ONE specifies filtering
status words for those where the BCR bit has a value of 1.
TRIGGER:A:BUS:B1:MIL1553B: STATUS:BIT:BCR? might return NOCARE,
indicating that status words are not being filtered based on the BCR bit value.
TRIGger:{A|B}:BUS:B<x>:MIL1553B:STATus:BIT:BUSY
This command sets or queries the value of the busy bit (BUSY bit, bit 16) in
a status word for a MIL-STD-1553 bus to triggering on. The bus number is
specified by x. The trigger condition must be set to STATus.
Conditions
Requires the SR-AERO Triggering and Analysis application.
Group
Trigger
MSO54, MSO56, MSO58, MSO58LP Programmer 2-823
To Next Page