Tektronix MSO58

Commands listed in alphabetical order
Examples
TRIGGER:A:BUS
:B1:LIN:DATA:VALUE "11001101"
sets the data value to
11001101.
TRIGGER:A:BU
S:B1:LIN:DATA:VALUE?
might return
TRIGGER:A:BUS:B1:LIN:DATA: VALUE "XXXXXXXX" indicating the
data value is don't care.
TRIGger:{A
|B}:BUS:B<x>:LIN:ERRTYPE
This command specifies the error type be used for LIN trigger. The bus number is
specified by <x>.
Conditions
Requires the SR-AUTO Triggering and Analysis application.
Group
Trigger
Syn
tax
TRIGger:{A|B}:BUS:B<x>:LIN :ERRTYPE {SYNC|PARity|CHe cksum}
TRIGger:{A|B}:BUS:B<x>:LIN :ERRTYPE?
Arguments
SYNC sets the LIN error type to SYNC.
PARity sets the LIN error type to parity.
CHecksum se ts the LIN error type to checksum.
Examples
TRIGGER:A:BUS:B1:LIN:ERRTY PE CHECKSUM sets the LIN error type to
checksum.
TRIGGER:A:BUS:B1:LIN:ERRTY PE? might return
TRIGGER:A:BUS:B1:LIN:ERRTY PE SYNC indicating the LIN error type
is SYNC.
TRIGger:{A|B}:BUS:B<x>:LIN:IDentifier:VALue
This command specifies the binary address string used for LIN bus trigger if the
trigger condition is ID or IDANDDATA. The bus number is specified by <x>.
Conditions
Requires the SR-AUTO Triggering and Analysis application.
Group
Trigger
MSO54, MSO56, MSO58, MSO58LP Programmer 2-813