Commands listed in alphabetical order
Group
Horizontal
Syntax
HORizontal:POSition <NR3>
HORizontal:POSition?
Arguments
<NR3> is from 0 to ≈100 and is the position of the trigger point on the screen (0 =
left edge, 100 = r
ight edge).
Examples
HORIZONTAL:POSITION 10 sets the trigger position of the waveform such that
10% of the display is to the left of the trigger position.
HORIZONTAL:POSITION? might return :HORIZONTAL:P OSITION
5.0000E+01
indicates the trigger point displayed on the screen.
HORizontal:PREViewstate? (Query Only)
This query returns the display system preview state.
Group
Horizontal
Syntax
HORizontal:PREViewstate?
Returns
<NR1> = 1 if the system is in the preview state.
<NR1> = 0 if the system is not in the preview state.
Examples
HORIZONTAL:PREVIEWSTATE? might return :HORIZONTAL:PREVIEWS TATE
0
indicating the system is not in the preview state.
HORizontal:RECOrdlength
This command sets or queries the horizontal record length. To change the record
length the Horizontal Mode must be set to Manual.
Group
Horizontal
Syntax
HORizontal:RECOrdlength <NR1>
HORizontal:RECOrdlength?
MSO54, MSO56, MSO58, MSO58LP Programmer 2-353
To Next Page
Loading...
