Tektronix MSO58

Commands listed in alphabetical order
Arguments
ONE filters stat
us words to only match those where the TF bit has a value of 1.
ZERo filters status words to only match those where the TF bit has a value of 0
.
NOCARE disables filtering of status words on the TF bit.
Examples
SEARCH:SEARCH1:TRIGGER:A:B US:MIL1553B:STATUS:BIT:TF ONE
specifies filtering status words for those where the TF bit has a value of 1.
SEARCH:SEARCH1:TRIGGER:A:B US:MIL1553B:STATUS:BIT:TF? might
return NOCARE, indicating that status words are not being filtered based on
the TF bit value.
SEARCH:SEARCH<x>:TRIGger:A:BUS:MIL1553B:STATus:PARity
This command sets or queries the value of the status word parity bit for a
MIL-STD-1553 bus to search on. The search number is specified by x. The search
condition must be set to STATus.
Conditions
Requires the SR-AERO Triggering and Analysis application.
Gro
up
Search and Mark
Syntax
SEARCH:SEARCH<x>:TRIGger:A :BUS:MIL1553B:STATus:PARity
{ONE|ZERo|NOCARE}
SEARCH:SEARCH<x>:TRIGger:A :BUS:MIL1553B:STATus:PARity?
Arguments
ONE filters status words to only match those where the parity bit has a value of 1.
ZERo filters status words to only match those where the parity bit has a value of 0.
NOCARE disables filtering of status words on the parity bit.
Examples
SEARCH:SEARCH1:TRIGGER:A:B US:MIL1553B:STATUS:PARITY ONE
specifies filtering status words for those where the parity bit has a value of 1.
SEARCH:SEARCH1:TRIGGER:A:B US:MIL1553B:STATUS:PARITY? might
return NOCARE, indicating that status words are not being filtered based on
the parity bit value.
SEARCH:SEARCH<x>:TRIGger:A:BUS:PARallel:DATa:VALue
This command sets or queries the binary data string used for a parallel b us search
to determine where to place a mark. The search number is specified by <x>.
MSO54, MSO56, MSO58, MSO58LP Programmer 2-695