Tektronix MSO58 User Manual

Commands listed in alphabetical order
HORizontal:M
ODE:SAMPLERate
This command sets or queries the sample rate.
Group
Horizontal
Syntax
HORizontal:MODE:SAMPLERat e <NR1>
HORizontal:MODE:SAMPLERat e?
Arguments
<NR1> is the sample rate in samples per se cond.
Examples
HORIZONTAL:MODE:SAMPLERAT E 1e6 sets the sample rate to 1 million samples
per second.
HORIZONTAL:MODE:SAMPLERAT E? might return
:HORIZONTAL:MODE:SAMPLERA TE 5.0000E+6, indicating that the sample rate
is set to 5 million samples per second.
HORizontal:MODE:SCAle
This command sets or queries the horizontal scale.
Group
Horizontal
Syntax
HORizontal:MODE:SCAle <NR1>
HORizontal:MODE:SCAle?
Arguments
<NR1> is the horizontal scale in seconds per division.
Examples
HORIZONTAL:MODE:SCALE 2e-9 sets the horizontal scale to 2 ns per division.
HORIZONTAL:MODE:SCALE? might return :HORIZONTAL:MOD E:SCALE
20.0000E-6
, indicating that the horizontal scale is set to 10 μs per division.
HORizontal:POSition
This command s ets or queries the horizontal position as a percent of screen
width. When Horizontal Delay Mode is turned off, this command is equivalent
to adjusting the HORIZONTAL POSITION knob o n the front panel. When
Horizontal Delay Mode is turned on, the horizontal position is forced to 5 0%.
2-352 MSO54, MSO56, MSO58, MSO58LP Programmer

Tektronix MSO58 Specifications

General

Brand	Tektronix
Model	MSO58
Category	Test Equipment
Language	English