Tektronix MSO58

Commands listed in alphabetical order
Syntax
SEARCH:SEARCH
<x>:TRIGger:A:BUS:I2C:DATa:S IZe <NR1>
SEARCH:SEARCH<x>:TRIGger:A :BUS:I2C:DATa:SIZe?
Arguments
<NR1> spe cifiesthedatasizeinbytes.
Examples
SEARCH:SEARCH1:TRIGGER:A:B US:I2C:DATA:SIZE 1 sets the length of the
data string for I2C bus trigger search 1 to 1 byte.
SEARCH:SEARCH1:TRIGGER:A:B US:I2C:DATA:SIZE? might return
:SEARCH:SEARCH1:TRIGGER:A: BUS:I2C:DATA:SIZE 3, indicating that the
length of the data string for I2C bus trigger search 1 is 3 bytes.
SEARCH:SEARCH<x>:TRIGger:A:BUS:I2C:DATa:VALue
This command sets or que ries the binary data string used for I2C bus search to
determine where to place a mark. The search number is specified by <x>. The
search condition must be DATA or ADDRANDDATA.
Conditions
Requires the SR-EMBD Triggering and Analysis application.
Group
Search and Mark
Syntax
SEARCH:SEARCH<x>:TRIGger:A :BUS:I2C:DATa:VALue <QStr ing>
SEARCH:SEARCH<x>:TRIGger:A :BUS:I2C:DATa:VALue?
Arguments
<QString> specifies the data value. The valid characters are 0, 1, or X for binary
format; and A-F, 0-9, and X for hexadecimal format.
Examples
SEARCH:SEARCH1:TRIGGER:A:B US:I2C:DATA:VALUE "1001" sets the data
value for I2C bus trigger search 1 to "1001".
SEARCH:SEARCH2:TRIGGER:A:B US:I2C:DATA:VALUE? might return
:SEARCH:SEARCH2:TRIGGER:A: BUS:I2C:DATA:VALUE "XX", indicating that
the data value for I2C bus trigger search is "XX" in hexadecimal format.
SEARCH:SEARCH<x>:TRIGger:A:BUS:LIN:CONDition
This command sets or queries the condition for a LIN bus search. The search
number is specified by <x>.
Conditions
Requires the SR-AUTO Triggering and Analysis application.
MSO54, MSO56, MSO58, MSO58LP Programmer 2-677