Tektronix MSO58

Commands listed in alphabetical order
POWer:POWer<
x>:DVDT:INPUTSOurce
This command sets or queries the input source for dv/dt measurement in the
specified power measurement badge. The power measurement badge is specified
by x.
Conditions
Requires option 5-PWR, SUP5-PWR, or 5-PS2.
Group
Power
Syntax
POWer:POWer<x>:DVDT:INPUT SOurce {CH<x> | MATH<x> | REF<x>}
POWer:POWer<x>:DVDT:INPUT SOurce?
Arguments
CH<x> = A channel specifier; <x> is 1 through 8 and is limited by the number
of FlexChannels in your instrument.
MATH<x> = A math waveform specifier; <x> is ≥1.
REF<x> = A reference waveform specifier; <x> is ≥1.
Examples
POWer:POWer1:DVDT:INPUTSO urce CH1 sets the input source for dv/dt
measurement as channel 1.
POWer:POWer<x>:DVDT:SOURCEEDGEType
This command sets or queries the edge type for dv/dt measurement in the specified
power measurement badge. The power measurement badge is specified by x.
Conditions
Requires option 5-PWR, SUP5-PWR, or 5-PS2.
Group
Power
Syntax
POWer:POWer<x>:DVDT:SOURC EEDGEType {RISE | FALL}
POWer:POWer<x>:DVDT:SOURC EEDGEType?
Examples
POWer:POWer1:DVDT:SOURCEE DGEType RISE setstheedgetypeasrisefor
the dv/dt measurement.
2-534 MSO54, MSO56, MSO58, MSO58LP Programmer