Tektronix MSO58

Commands listed in alphabetical order
Related Commands
SEARCH:SEARCH
<x>:TRIGger:A:BUS:ETHERnet:CONDition
SEARCH:SEARCH<x>:TRIGger:A:BUS:ETHERnet:DATa:VALue
SEARCH:SEARCH<x>:TRIGger:A:BUS:ETHERnet:DATa:SIZe
Arguments
<NR1> is a
n integer whose minimum and default values are -1 (don't care) and
maximum is 1,499.
Examples
SEARCH
:SEARCH1:TRIGGER:A:BUS:ETH ERNET:DATA:OFFSEt 36
sets the
data offset to 36 bytes.
SEARCH:SEARCH1:TRIGGER:A:B US:ETHERNET:DATA:OFFSET? might return
-1, indicating that the data offset value is the default value, -1, meaning "don’t
care".
SEARCH:SEARCH<x>:TRIGger:A:BUS:ETHERnet:DATa:QUALifier
This command specifies the qualifier to be used when searching on an Ethernet
bus signal. The search condition must be set to
DATa. The search number is
specified by <x>.
Conditions
Requires the SR-ENET Triggering and Analysis application.
Group
Search and Mark
Syntax
SEARCH:SEARCH<x>:TRIGger:A :BUS:ETHERnet:DATa:QUALifier
{LESSthan|MOREthan|EQual|U NEQual|LESSEQual|MOREEQual|
INrange|OUTrange}
SEARCH:SEARCH<x>:TRIGger:A :BUS:ETHERnet:DATa:QUALifier?
Related Commands
SEARCH:SEARCH<x>:TRIGger:A:BUS:ETHERnet:CONDition
Arguments
LESSthan sets the qualifier to less than.
MOREthan sets the qualifier to greater than.
EQual sets the qualifier to equal.
UNEQual sets the qualifier to not equal.
LESSEQual sets the qualifier to less than or equal.
MOREEQual sets the qualifier to greater than or equal.
MSO54, MSO56, MSO58, MSO58LP Programmer 2-651