Tektronix MSO58 - MEASUrement:MEAS<x>:CLOCKRecovery:METHod; MEASUrement:MEAS<x>:CLOCKRecovery:MODel

Commands listed in alphabetical order
Syntax
MEASUrement:M
EAS<x>:CLOCKRecovery:MEANAUT OCalculate
{FIRST|EVERY}
MEASUrement:MEAS<x>:CLOCKR ecovery:MEANAUTOCalculate?
Arguments
FIRST calculates the clock on the first acquisition.
EVERY calculates the clock on every acquisition.
Examples
MEASUrement:MEAS1:CLOCKRec overy:MEANAUTOCalculate E VERY causes
the clock to be calculated on every acquisition.
MEASUrement:MEAS1:CLOCKRec overy:MEANAUTOCalculate? might return
:MEASUREMENT:MEAS1:CLOCKRE COVERY:MEANAUTOCALCULATE FIRST
indicating the clock is calculated on the first acquisition.
MEASUrement:MEAS<x>:CLOCKRecovery:METHod
This command sets or queries the clock recovery method for the measurement.
Measurements are specified by x.
Group
Measurement
Syntax
MEASUrement:MEAS<x>:CLOCKR ecovery:METHod
{PLL|CONSTANTCLOCK|EXPLICI TCLOCK}
MEASUrement:MEAS<x>:CLOCKR ecovery:METHod?
Arguments
PLL specifies a phase locked loop clock recovery method.
CONSTANTCLOCK specifies using a constant clock.
EXPLICITCLOCK specifies using an explicit clock.
Examples
MEASUrement:MEAS1:CLOCKRec overy:METHod PLL specifies a phase locked
loop clock recovery method.
MEASUrement:MEAS1:CLOCKRec overy:METHod? might return
:MEASUREMENT:MEAS1:CLOCKRE COVERY:METHOD CONSTANTCLOCK
indicating a constant clock is in u se.
MEASUrement:MEAS<x>:CLOCKRecovery:MODel
This command s ets or que ries the PLL clock recovery model used w h en PLL
clock recovery is used for the measurement. Measureme nts are specified by x.
MSO54, MSO56, MSO58, MSO58LP Programmer 2-437