Tektronix MSO58 User Manual (English)

To Next Page

To Previous Page

Commands listed in alphabetical order

MEASUrement:

REFLevels:MODE

This command sets or queries how often reference levels are calculated.

Group

Measurement

Syntax

MEASUrement:REFLevels:MOD E {LATCh|CONTinuous}

MEASUrement:REFLevels:MOD E?

Arguments

LATCh calculate s reference levels only on the ﬁrst acquisition after a statistics

reset.

CONTinuous calculates reference levels on every acquisition.

Examples

MEASUREMENT:REFLEVELS:MOD E CONTINUOUS calculates reference levels on

every acquisition.

MEASUREMENT:REFLEVELS:MOD E? might return

:MEASUREMENT:REFLEVELS:MO DE LATCH indicating reference levels are

calculated only on the ﬁrst acquisition after a statistics reset.

MEASUrement:REFLevels:PERCent:FALLHigh

This command sets or queries the percentage (where 100% is equal to TOP and

0% is equal to BASE) used to calculate the high reference level of the falling edge

when the measurement's ref level method is set to percent.

Group

Measurement

Syntax

MEASUrement:REFLevels:PER Cent:FALLHigh <NR3>

MEASUrement:REFLevels:PER Cent:FALLHigh?

Arguments

<NR3> is the percentage used to calculate the high reference level of the falling

edge

Examples

MEASUrement:REFLevels:PER Cent:FALLHigh 90 sets the h igh reference

level to 90%.

MEASUrement:REFLevels:PER Cent:FALLHigh? might return

:MEASUREMENT:REFLEVELS:PE RCENT:FALLHIGH 80.0000 indicating the

high reference level is 80%.

2-502 MSO54, MSO56, MSO58, MSO58LP Programmer

Tektronix MSO58 User Manual