Commands listed in alphabetical order
ETHERnet:LXI
:LAN:STATus? (Query Only)
This query returns the LXI network s tatus: one of OK, FAULT, or IDENTIFY.
IDENTIFY indicates that the device identify mode is enabled.
Group
Ethernet
Syntax
ETHERnet:LXI:LAN:STATus?
Related Commands
ETHERnet:PING,
ETHERnet:PING:STATus?
Returns
OK — indicates the network is running and the oscilloscope can “see” the network.
FAULT — indicates the network is not visible, or the network settings are incorrect.
IDENTIFY indicates that a message is being displayed on the oscilloscope’s front
panel indicating which scope the u ser is currently accessing.
Examples
ETHER:LXI:LAN:STAT? might return FAULT, indicating the network is not
visible, or the network settings are incorrect.
ETHERnet:NAME
This command sets or queries the instrument Ethernet hostname assigned to the
oscilloscope.
Group
Ethernet
Syntax
ETHERnet:NAME <QString>
ETHERnet:NAME?
Arguments
<QString> is the network name assigned to the oscilloscope, enclosed in quotes.
Examples
ETHERNET:NAME "labscope1" sets the oscilloscope's network name.
ETHERnet:NETWORKCONFig
This command specifies the Ethernet network configuration setting.
2-326 MSO54, MSO56, MSO58, MSO58LP Programmer
To Next Page
Loading...
