To Next Page

To Previous Page

Commands listed in alphabetical order

POWer:POWer<

x>:RESUlts:ALLAcqs:MEAN? (Query Only)

This command queries the mean value of all acquisitions for the measurement

parameter in the speciﬁed power m easurement badge. The power measurement

badge is spec

iﬁed by x.

Conditions

Requires option 5-PWR, SUP5-PWR, or 5-PS2.

Group

Power

Syntax

POWer:POWer<x>:RESUlts:ALL Acqs:MEAN? <QString>

Arguments

<QString> = parameters of the mea surements. The details of the parameters for

the Power measurements are listed below:

For Power Quality measurement, the parameters are "TRUEPWR" | "APPPWR"

"VCFACTOR" | "IRMS" | "VRMS".

For Switching Loss measurement, the parameters are "TONENRG" | "TONLOSS"

"TTLENRG".

For dV by dt m easurement, the parameter is “DVBYDT”.

FordIbydtmeasurement,theparameteris“DIBYDT”.

For SOA measurement, the p arameter is “SOAHITSCNT”.

For Line Ripple measurement, the parameters are “LRIPRMS” | “LRIPPKPK”.

For Switching Ripple measurement, the parameters are “SWRIPRMS” |

“SWRIPPKPK”.

For Cycle Period measurement, the parameters is “PRIOD”.

For Cycle Frequency meas urement, the parameters is “FREQ”.

For Positive Duty Cycle measurement, the parameters is “PDUTY”.

For Negative Duty Cycle measurement, the parameters is “NDUTY”.

For Positive Pulse Width measurement, the parameters is “PPULSE”.

For Negative Pulse Width measurement, the p arameters is “NPULSE”.

For Cycle Amplitude measurement, the parameters is “AMPL”.

For Cycle Peak–Peak measurement, the parameters is “PKPK”.

For Cycle Top measurement, the parameters is “HIGH”.

MSO54, MSO56, MSO58, MSO58LP Programmer 2-563

Tektronix MSO58 User Manual

Other manuals for Tektronix MSO58