Tektronix MSO58 User Manual

Commands listed in alphabetical order
Examples
SEARCH:SEARCH
1:TRIGger:A:BUS:AUDio:DATa:H ITDMVALue
"XXXXXXXXXXXXXXXXXXXX1100 "
sets the high value to 1100.
SEARCH:SEARC
H1:TRIGger:A:BUS:AUDio:DAT a:HITDMVALue?
might
return
:SEARCH:SEARCH1:TRIGGER:A: BUS:AUDIO:DATA:HITDMVALUE
"XXXXXXXXXXXXXXXXXXXX1010 "
indicating the high value is set to 1010.
SEARCH:SEA
RCH<x>:TRIGger:A:BUS:AUDio:DATa:HIVALue
This command sets or queries the binary data string for the high data word to be
used when searching on an audio bus signal. The search condition must be set
to DATa us
ing
:SEARCH:SEARCH<x>:TRIGger:A :BUS:AUDio:CONDition.
The search number is specified by <x>.
Group
Search and Mark
Syntax
SEARCH:SEARCH<x>:TRIGger: A:BUS:AUDio:DATa:HIVALue <QString>
SEARCH:SEARCH<x>:TRIGger: A:BUS:AUDio:DATa:HIVALue?
Arguments
<QString> specifies the upper word value.
Examples
SEARCH:SEARCH1:TRIGger:A: BUS:AUDio:DATa:HIVALue “X XXX” sets
the
HIVALUE to XXXX.
SEARCH:SEARCH1:TRIGger:A: BUS:AUDio:DATa:HIVALue? might
return
:SEARCH:SEARCH1:TRIGGER:A:BU S:AUDIO:DATA:HIVALUE
"TEST_001101"
indicating the HIVALUE is set to TEST_001101.
SEARCH:SEARCH<x>:TRIGger:A:BUS:AUDio:DATa:OFFSet
This command sets or queries the data offset value (TDM channel) to be used when
searching o n a TDM type audio bus signal. The search condition must be set to
DATa using
SEARCH:SEARCH<x>:TRIGger:A:B US:AUDio:TDM:CONDition.
The search number is specified by <x>.
Conditions
Requires the SR-AUDIO Triggering and Analysis application.
Group
Search and Mark
Syntax
SEARCH:SEARCH<x>:TRIGger: A:BUS:AUDio:DATa:OFFSet < NR1>
SEARCH:SEARCH<x>:TRIGger: A:BUS:AUDio:DATa:OFFSet?
2-638 MSO54, MSO56, MSO58, MSO58LP Programmer

Tektronix MSO58 Specifications

General

Brand	Tektronix
Model	MSO58
Category	Test Equipment
Language	English