Commands listed in alphabetical order
Examples
TRIGGER:A:BUS
:B1:USB:ENDPOINT:VALUE "1000"
sets the binary address
to 1000 (08 hex).
TRIGGER:A:BUS:B1:USB:ENDPO INT:VALUE? might return
:TRIGGER:A:BUS:B1:USB:ENDP OINT:VALUE "1001", which indicates that
the binary address is 1001 (09 hex).
TRIGger:{A|B}:BUS:B<x>:USB:ERRType
This command specifies the error type to be used when the trigger condition is
set to ERRor. The bus number is specified by <x>.
Conditions
Requires the SR-USB2 Serial Triggering and Analysis Application.
Group
Trigger
Syntax
TRIGger:{A|B}:BUS:B<x>:USB :ERRType
{PID|CRC5|CRC16|BITSTUFFin g}
TRIGger:{A|B}:BUS:B<x>:USB :ERRType?
Related Commands
TRIGger:{A|B}:BUS:B<x>:USB:CONDition
Arguments
PID indicates the error type is set to packet ID.
CRC5 indicates the error type is set to 5-bit CRC.
CRC16 indicates the error type is set to 16-bit CRC.
BITSTUFFing indicates the error type is set to bit stuffing.
Examples
TRIGGER:A:BUS:B1:USB:ERRTY PE PID sets the error trigger condition to
packet ID.
TRIGGER:A:BUS:B1:USB:ERRTY PE? might return
:TRIGGER:A:BUS:B1:USB:TYPE PID, indicating the error trigger condition is
packet ID.
TRIGger:{A|B}:BUS:B<x>:USB:HANDSHAKEType
This command spe cifies the handshake type for the USB trigger. The bus number
is specified by <x>.
Conditions
Requires the SR-USB2 Serial Triggering and Analysis Application.
MSO54, MSO56, MSO58, MSO58LP Programmer 2-841
To Next Page
Loading...
Need help?
General
