Tektronix MSO58 - TRIGger:{A|B}:BUS:B<x>:ETHERnet:CONDition

Commands listed in alphabetical order
TRIGger:{A|B
}:BUS:B<x>:ETHERnet:CONDition
This command specifies a field or condition within an Ethernet frame to trigger
on. The bus number is specified by <x>.
Conditions
Requires the SR-ENET Triggering and Analysis application.
Group
Trigger
Syntax
TRIGger:{A|B}:BUS:B<x>:ETH ERnet:CONDition
{SFD|MACADDRess|MACLENgth| IPHeader|TCPHeader|DATa|EOP|
IDLe|FCSError|QTAG}
TRIGger:{A|B}:BUS:B<x>:ETH ERnet:CONDition?
Related Commands
Most of the other TRIGger: A:BUS:B<x>:ETHER net
commands are impacted
by the setting of this command.
Arguments
SFD — Start of frame delimiter.
MACADDRess — MAC addresses field.
MACLENgth —MAC
length/type field.
IPHeader —IPheaderfield. This argument is only available when PROTOCOL
is set to IPv4.
TCPHeader — TCP header field. This argument is only available when
PROTOCOL is s
et to IPv4.
DATa — TCP/IPv4 or MAC protocol client data field. If the protocol is set to
OTHER, then
DATa refers to the M AC client data.
EOP — End of Packet field.
IDLe —Idlefield.
FCSError — Frame Check Sequence Error (CRC) field.
QTAG — IEEE 802.1Q (VLAN) control information field. In order to use QTAG as
a trigger condition, the frame type must be set to QTAG ).
Examples
TRIGger:A:BUS:B1:ETHERnet: CONDition MACADDRess sets the trigger
field to
MACADDRess.
TRIGger:A:BUS:B1:ETHERnet: CONDition? might return DATA.
MSO54, MSO56, MSO58, MSO58LP Programmer 2-779