Tektronix MSO58

Commands listed in alphabetical order
BUS:B<x>:CAN
:SIGNal
This command sets or queries the signal type for the specified CAN bus. The
bus is specified by x.
Conditions
Requires option SR-AUTO.
Group
Bus
Syntax
BUS:B<x>:CAN:SIGNal {DIFFerential|C ANH|CANL|RX|TX}
BUS:B<x>:CAN:SIGNal?
Arguments
Arguments are the CAN bus signal types.
Examples
BUS:B1:CAN:SINal CANL sets the signal type to CANL.
BUS:B1:CAN:SINal? might return :BUS:B1:CAN:SIGNAL CANH indicating
the s ignal type is CANH.
BUS:B<x>:CAN:SOUrce
This command sets or queries the CAN source channel for the specified CAN
bus. The bus number is specified by x.
Conditions
Requires option SR-AUTO.
Group
Bus
Syntax
BUS:B<x>:CAN:SOUrce
{CH<x>|CH<x>_D<x>|MATH<x> |REF<x>|REF<x>_D<x>}
BUS:B<x>:CAN:SOUrce?
Arguments
Arguments specify a channel.
Examples
BUS:B1:CAN:SOUrce MATH6 sets the source channel to MATH6.
BUS:B1:CAN:SOUrce? might return :BUS:B1:CAN:SOU RCE CH1, indicating
that the CAN source channel is CH1.
2-130 MSO54, MSO56, MSO58, MSO58LP Programmer