Commands listed in alphabetical order
CH<x>:PRObe:
AUTOZero (No Query Form)
This command executes the attached probe’s Auto Zero function, for probes that
support this feature. See your probe documentation for more details. The channel
is specified b
yx.
Group
Vertical
Syntax
CH<x>:PRObe:AUTOZero EXECute
Arguments
EXECute sets the probe attached to the specified channel to autozero.
Examples
CH1:PROBE:AUTOZERO EXECUTE sets the probe attached to the Channel 1 to
autozero.
CH<x>:PRObe:DEGAUSS (No Query Form)
This command starts a degauss cycle of the TekVPI probe attached to the specified
channel. The channel is specified by x.
Group
Vertical
Syntax
CH<x>:PRObe:DEGAUSS EXECute
Arguments
EXECute starts the degauss cycle.
Examples
CH1:PROBE:DEGAUSS EXECUTE causes the probe attached to Channel 1 to
degauss.
CH<x>:PRObe:DEGAUSS:STATE? (Query Only)
This command queries whether the probe attached to the specified channel
requires a degauss operation. The channel is s pecified by x.
Group
Vertical
Syntax
CH<x>:PRObe:DEGAUSS:STATE ?
2-196 MSO54, MSO56, MSO58, MSO58LP Programmer
To Next Page