Tektronix MSO58

Commands listed in alphabetical order
For Cycle Base m
easurement, the parameters is “LOW”.
For Cycle Max measurement, the parameters is “MAX”.
For Cycle Min measurement, the parameters is “MIN”.
Examples
POWer:POWer1:RESUlts:CURR entacq:POPUlation? “CondEnrg” might
return 9.91E+37, indicating the population (number of complete cycles) of
conduction energy for the current acquisition.
POWer:POWer<x>:RESUlts:CURRentacq:RMS? (Query Only)
This command queries the RMS value of the source selected for the specified
power measurement badge. The power measurement badge is specified by x.
Conditions
Requires option 5-PWR, SUP5-PWR, or 5-PS2.
Group
Power
Syntax
POWer:POWer<x>:RESUlts:CU RRentacq:RMS? "harmonics"
Examples
POWer:POWer1:RESUlts:CURR entacq:RMS? "harmonics" might return
1.4143420437461, indicating the RMS value of the source selected for the power
measurement badge 1.
POWer:POWer<x>:RESUlts:CURRentacq:STATUS? (Query Only)
This command queries the status of the measurement for the specified power
measurement badge. The power measurement badge is specified by x.
Conditions
Requires option 5-PWR, SUP5-PWR, or 5-PS2.
Group
Power
Syntax
POWer:POWer<x>:RESUlts:CU RRentacq:STATUS? "harmonics"
Examples
POWer:POWer1:RESUlts:CURR entacq:STATUS? "harmonics" might return
“Pass”, indicating that the measurement has passed according to the standard
for the power measurement badge 1.
2-578 MSO54, MSO56, MSO58, MSO58LP Programmer