To Next Page

To Previous Page

Commands listed in alphabetical order

For Cycle Base m

easurement, the parameters is “LOW”.

For Cycle Max measurement, the parameters is “MAX”.

For Cycle Min measurement , the parameters is “MIN”.

Examples

POWer:POWer1:RESUlts:CURRe ntacq:STDDev? “TONLoss” might

return 9.91E+37, indicating the standard deviation value of Ton Energy for all

acquisitions.

POWer:POWer<x>:RESUlts:CURRentacq:F1MAG? (Query Only)

This command queries the ﬁrst harmonics magnitude value for the speciﬁed

power measurement badge. The power measurement badge is speciﬁed by x.

Conditions

Requires option 5-PWR, SUP5-PWR, or 5-PS2.

Group

Power

Syntax

POWer:POWer<x>:RESUlts:CUR Rentacq:F1MAG? "harmonics"

Examples

POWer:POWer1:RESUlts:CURRe ntacq:F1MAG? "harmonics" might return

1.4151834770090, indicating the value of the ﬁ rst harmonics magnitude for the

power measurement badge 1.

POWer:POWer<x>:RESUlts:CURRentacq:F3MAG? (Query Only)

This command queries the third harmonics magnitude value for the speciﬁed

power measurement badge. The power measurement badge is speciﬁed by x.

Conditions

Requires option 5-PWR, SUP5-PWR, or 5-PS2.

Group

Power

Syntax

POWer:POWer<x>:RESUlts:CUR Rentacq:F3MAG? "harmonics"

Examples

POWer:POWer1:RESUlts:CURRe ntacq:f3MAG? "harmonics" might return

234.0187140104806E-6, indicating the value of third harmonics magnitude for

the power measurement badge 1.

MSO54, MSO56, MSO58, MSO58LP Programmer 2-569

Tektronix MSO58 User Manual

Other manuals for Tektronix MSO58