Tektronix MSO58 User Manual

Commands listed in alphabetical order
Syntax
TRIGger:{A|B}
:BUS:B<x>:FLEXray:HEADER:PAY Length <QString>
TRIGger:{A|B}:BUS:B<x>:FL EXray:HEADER:PAYLength?
Arguments
<QStrin
g>
is the length o f the payload portion of the Binary header string.
Examples
TRIGGER:A:BUS:B1:FLEXRAY: HEADER:PAYLENGTH "1100101" sets the
FlexRay header paylength to 1100101.
TRIGGER:A:BUS:B1:FLEXRAY: HEADER:PAYLENGTH? might return
TRIGGER:A:BUS:B1:FLEXRAY: HEADER:PAYLENGTH "XXXXXXX" indicating
the FlexRay header paylength is don't care.
TRIGger:{A|B}:BUS:B<x>:I2C:ADDRess:MODe
This command specifies the I
2
C address mode to 7 or 10-bit. The bus number is
specified by <x>.
Conditions
Requires the SR-EMBD Triggering and Analysis application.
Group
Trigger
Syntax
TRIGger:{A|B}:BUS:B<x>:I2 C:ADDRess:MODe {ADDR7|ADDR10 }
TRIGger:{A|B}:BUS:B<x>:I2 C:ADDRess:MODe?
Arguments
ADDR7 specifies the 7-bit I
2
C address mode.
ADDR10 specifi es the 10-bit I
2
C address mode.
Examples
TRIGGER:A:BUS:B1:I2C:ADDR ESS:MODE ADDR10 sets the I2C address mode
to 10-bit.
TRIGGER:A:BUS:B1:I2C:ADDR ESS:MODE? might return
:TRIGGER:A:BUS:B1:I2C:ADD RESS:MODE ADDR7 indicating the
address mode is set to the 7-bit mode.
TRIGger:{A|B}:BUS:B<x>:I2C:ADDRess:VALue
This command specifies the binary address string used for the I
2
C trigger if
the trigger condition is ADDRESS or ADDRANDDATA. The bus numbe
ris
specified by <x>.
2-806 MSO54, MSO56, MSO58, MSO58LP Programmer

Tektronix MSO58 Specifications

General

Brand	Tektronix
Model	MSO58
Category	Test Equipment
Language	English