Tektronix MSO58 - TRIGger:{A|B}:LOGICPattern:{CH<x>|CH<x>_D<x>}; TRIGger:{A|B}:LOWerthreshold:CH<x>

Commands listed in alphabetical order
TRIGger:A:LOG
Ic:WHEn?
might return :TRIGGER:A:LOGIC:WHEN TRUE
indicating a trigger when the logic is true.
TRIGger:{A|B}:LOGICPattern:{CH<x>|CH<x>_D<x>}
This command sets or queries the Logic Pattern that is used along with the Define
Logic choice (
LOGIc:FUNCtion) to determine when the logic trigger occurs.
Group
Trigger
Syntax
TRIGger:{A|B}:LOGICPattern :{CH<x>|CH<x>_D<x>} {HIGH |LOW|X}
TRIGger:{A|B}:LOGICPattern :{CH<x>|CH<x>_D<x>}?
Arguments
HIGH specifies the logic high.
LOW specifiesthelogiclow.
X specifiesadon'tcarestate.
Examples
TRIGger:A:LOGICPattern:CH1 HIGH specifies triggering on a logic high.
TRIGger:A:LOGICPattern:CH1 ? might return
:TRIGGER:A:LOGICPATTERN:CH 1 X indicating a don’t care state for channel 1.
TRIGger:A:LOGICPattern:CH1 _D0 HIGH specifies a logic high.
TRIGger:A:LOGICPattern:CH1 _D0? might return
:TRIGGER:A:LOGICPATTERN:CH 1_D0 X indicating a don’t care.
TRIGger:{A|B}:LOWerthreshold:CH<x>
This command sets or queries the A or B lower trigger level threshold for the
channel, specified by x.
Group
Trigger
Syntax
TRIGger:{A|B}:LOWerthresho ld:CH<x> <NR3>
TRIGger:{A|B}:LOWerthresho ld:CH<x>?
Related Commands
TRIGger:{A|B}:UPPerthreshold:CH<x>
Arguments
<NR3> specifies the threshold voltage in user units.
MSO54, MSO56, MSO58, MSO58LP Programmer 2-855