Tektronix MSO58 User Manual

Commands listed in alphabetical order
Group
Search and Mark
Syntax
SEARCH:SEARCH<x>:TRIGger: A:BUS:PARallel:DATa:VALue <QString>
SEARCH:SEARCH<x>:TRIGger: A:BUS:PARallel:DATa:VALue?
Arguments
<QString> specifies the data value in a v alid format. Valid characters are 0-9,
Examples
SEARCH:SEARCH2:TRIGGER:A: BUS:PARALLEL:DATA:VALUE " XXXXXXXX"
sets the string data value to "XXXXXXXX" in binary format.
SEARCH:SEARCH1:TRIGGER:A: BUS:PARALLEL:DATA:VALUE? might
return
:SEARCH:SEARCH1:TRIGGER:A: BUS:PARALLEL:DATA:VALUE
"XXXXXXXXXXXXXXX10010"
, indicating that the data value string is set to
"XXXXXXXXXXXXXXX10010" in binary format.
SEARCH:SEARCH<x>:TRIGger:A:BUS:RS232C:CONDition
This command sets or queries the condition for an RS232C bus search to
determine where to place a mark. The search number is specified by <x>.
Conditions
Requires the SR-COMP Serial Triggering and Analysis Application.
Group
Search and Mark
Syntax
SEARCH:SEARCH<x>:TRIGger: A:BUS:RS232C:CONDition
{DATa|EOp|PARItyerror|STA Rt}
SEARCH:SEARCH<x>:TRIGger: A:BUS:RS232C:CONDition?
Arguments
DATa specifies the search condition as Data.
EOp spec ifies the search condition as End of Packet.
PARItyerror specifies the search condition as Parity Error.
STARt specifies the search condition as Start.
Examples
SEARCH:SEARCH1:TRIGGER:A: BUS:RS232C:CONDITION DATA sets the
search condition for RS232C bus trigger search 1 to Data.
SEARCH:SEARCH2:TRIGGER:A: BUS:RS232C:CONDITION? might return
:SEARCH:SEARCH2:TRIGGER:A :BUS:RS232C:CONDITION EOP, indicating
that the search condition for RS232C bus trigger search 2 is set to End of Packet.
2-696 MSO54, MSO56, MSO58, MSO58LP Programmer

Tektronix MSO58 Specifications

General

Brand	Tektronix
Model	MSO58
Category	Test Equipment
Language	English