Tektronix MSO58 User Manual

Commands listed in alphabetical order
Arguments
ACK specifies th
e handshake type as Acknowledgement (positive) (XX10).
ANY specifies the handshake type as Any (0010).
NAK specifies the handshake type as Negative Acknowledgment (1010).
NYET specifies the handshake type as No response Yet (0110).
STALL specifies the h andshake type as Stall (endpoint is halted or control pipe
request not supported) (1110).
Examples
SEARCH:SEARCH1:TRIGGER:A: BUS:USB:HANDSHAKETYPE NAK sets the
handshake type for USB bus trigger search 1 to NAK.
SEARCH:SEARCH2:TRIGGER:A: BUS:USB:HANDSHAKETYPE? might return
:SEARCH:SEARCH2:TRIGGER:A :BUS:USB:HANDSHAKETYPE NY ET, indicating
that the handshake type for USB bus trigger search 2 is set to NYET.
SEARCH:SEARCH<x>:TRIGger:A:BUS:USB:SOFFRAMENUMber
This command sets or queries the frame number string to use for the Start of Frame
for the specified USB bus trigger search to determine where to place a mark. The
search number is specifi ed by <x>. The search condition must be set to TOKEN.
Conditions
Requires the SR-USB2 Serial Triggering and Analysis Application.
Group
Search and Mark
Syntax
SEARCH:SEARCH<x>:TRIGger: A:BUS:USB:SOFFRAMENUMber <QString>
SEARCH:SEARCH<x>:TRIGger: A:BUS:USB:SOFFRAMENUMber?
Arguments
<QString> specifies the frame number string for the Start of Frame in a valid
format (binary, hexadecimal, or symbolic).
Examples
SEARCH:SEARCH1:TRIGGER:A: BUS:USB:SOFFRAMENUMBER "1 001" sets
the frame number string for the SOF for USB bus trigger search 1 to "1001" in
symbolic format.
SEARCH:SEARCH1:TRIGGER:A: BUS:USB:SOFFRAMENUMBER? might
return
:SEARCH:SEARCH1:TRIGGER:A:BU S:USB:SOFFRAMENUMBER
"xxxxxxx1001"
, indicating that the frame number string for the SOF for USB
bus trigger search 1 is set to "XXXXXXX1001" in binary format.
2-708 MSO54, MSO56, MSO58, MSO58LP Programmer

Tektronix MSO58 Specifications

General

Brand	Tektronix
Model	MSO58
Category	Test Equipment
Language	English