Tektronix MSO58

Commands listed in alphabetical order
PLOT:PLOT<x>
:NUMBins
This command sets or que ries the current histogram resolution.
Group
Plot
Syntax
PLOT:PLOT<x>:NUMBins {TWENtyfive|FI FTY|HUNdred|TWO Fifty|
FIVEHundred|TWOThousand|M AXimum}
Arguments
Arguments are the number of bins.
Examples
PLOT:PLOT4:NUMBins TWENTYFIVE sets the number of bins to 25.
PLOT:PLOT4:NUMBins? might return :PL OT:PLOT4:NUMBINS TWOFIFTY
indicating the histogram resolution is 250 bins.
PLOT:PLOT<x>:SOUrce<x>
This command sets or queries the plot source.
Group
Plot
Syntax
PLOT:PLOT<x>:SOUrce<x> MEAS<x>
PLOT:PLOT<x>:SOUrce<x>?
Arguments
MEAS<x> is the specified measurement source for the specified plot.
Examples
PLOT:PLOT1:SOUrce1 MEAS2 sets source 1 of plot 1 to measurement 2.
PLOT:PLOT1:SOUrce1? might return :PLOT:PLOT1:SOURCE1 MEAS1
indicating the specified source of the specified plot is measurement 1.
PLOT:PLOT<x>:SPECtrum:BASE
This command sets or queries the sp
ectrum base. Undefined for non-spectrum
plots.
Group
Plot
2-526 MSO54, MSO56, MSO58, MSO58LP Programmer