Tektronix MSO58

Commands listed in alphabetical order
Syntax
MEASUrement:M
EAS<x>:CLOCKRecovery:JTFBand width <NR3>
MEASUrement:MEAS<x>:CLOCK Recovery:JTFBandwidth?
Arguments
<NR3> is the clock recovery JTF bandwidth.
Examples
MEASUrement:MEAS1:CLOCKRe covery:JTFBandwidth 1.10E +6 sets the
bandwidth to 1.1 MHz.
MEASUrement:MEAS1:CLOCKRe covery:JTFBandwidth? might return
:MEASUREMENT:MEAS1:CLOCKR ECOVERY:JTFBANDWIDTH 1.00 00E+6
indicating the bandwidth is 1.0 MHz.
MEASUrement:MEAS<x>:CLOCKRecovery:LOOPBandwidth
This command sets or queries the loop bandwidth used when PLL cl ock recovery
is used for the measurement. Measurements are specified by x.
Group
Measurement
Syntax
MEASUrement:MEAS<x>:CLOCK Recovery:LOOPBandwidth <N R3>
MEASUrement:MEAS<x>:CLOCK Recovery:LOOPBandwidth?
Arguments
<NR3> is the clock recovery loop bandwidth.
Examples
MEASUrement:MEAS1:CLOCKRe covery:LOOPBandwidth 1.10 E+6 sets the
bandwidth to 1.1 Mhz.
MEASUrement:MEAS1:CLOCKRe covery:LOOPBandwidth? might return
:MEASUREMENT:MEAS1:CLOCKR ECOVERY:LOOPBANDWIDTH 1.0 000E+6
indicating the bandwidth is 1.0 MHz.
MEASUrement:MEAS<x>:CLOCKRecovery:MEANAUTOCalculate
This command sets or queries how o ften the clock is calculated when constant
clock recovery is used for the measurement. The measurement number is
specified by x.
Group
Measurement
2-436 MSO54, MSO56, MSO58, MSO58LP Programmer