Tektronix MSO58

Commands listed in alphabetical order
SEARCH:SEARCH
1:TRIGGER:A:TIMEOUT:TIME?
might return
:SEARCH:SEARCH1:TRIGGER:A: TIMEOUT:TIME 500.0000E-12, indicating
that the timeout trigger time setting for search 1 is set to 500 ns.
SEARCH:SEAR
CH<x>:TRIGger:A:TRANsition:DELTATime
This command sets or queries the transition time setting for a transition trigger
search to determine where to place a mark. The search number is specified by <x>.
Group
Search and Mark
Syntax
SEARCH:SEARCH<x>:TRIGger:A :TRANsition:DELTATime <NR 3>
SEARCH:SEARCH<x>:TRIGger:A :TRANsition:DELTATime?
Arguments
<NR3> specifies the transition time in seconds.
Examples
SEARCH:SEARCH1:TRIGGER:A:T IMEOUT:TIME 400E-9 sets the transition
trigger time setting for search 1 to 400 ns.
SEARCH:SEARCH1:TRIGGER:A:T RANSITION:DELTATIME? might return
:SEARCH:SEARCH1:TRIGGER:A: TRANSITION:DELTATIME 500. 0000E-12,
indicating that the transition trigger time setting for search 1 is set to 500 ps.
SEARCH:SEARCH<x>:TRIGger:A:TRANsition:LOGICQUALification
This command specifies whether or not to use logic qualification for a transition
search. The search number is specified by <x>.
Group
Search and Mark
Syntax
SEARCH:SEARCH<x>:TRIGger:A :TRANsition:LOGICQUALification
{ON|OFF}
SEARCH:SEARCH<x>:TRIGger:A :TRANsition:LOGICQUALification?
Arguments
ON specifies to use logic qualification for a transition search.
OFF specifies not to u
se logic qualification for a transition search.
Examples
SEARCH:SEARCH1:TRIGger:A:T RANsition:LOGICQUALification ON
specifies to use logic qualification for a transition search.
MSO54, MSO56, MSO58, MSO58LP Programmer 2-741