Tektronix MSO58

Commands listed in alphabetical order
Related Commands
BUS:B<x>:TYPe
, DISplay:WAVEView<x>:BUS:B<x>:STATE
Arguments
<QString> is a quoted string of the form "B<NR1>" where NR1 is ≥1.
Examples
BUS:ADDNEW "B5"; :display:wavevi ew1:bus:b5:state on creates bus 3
with the defau
lt type of Parallel, and then turns it on.
BUS:B<x>:ARINC429A:BITRate
This command sets of queries the ARINC429 bit rate for the specified
bus. The bus n umber is specified by x. If you select Custom, u se
BUS:B<x>:ARINC429A:BITRat e:CUSTom to set the bit rate.
Conditions
Requires option SR-AERO.
Group
Bus
Syntax
BUS:B<x>:ARINC429A:BITRat e {LOW|HI|CUSTom}
BUS:B<x>:ARINC429A:BITRat e?
Related Commands
BUS:B<x>:ARINC429A:BITRate:CUSTom
Arguments
Arguments specify the bit rate.
Examples
BUS:B1:ARINC429A:BITRATE LOW sets the bit rate to handle low speed signals.
BUS:B1:ARINC429A:BITRATE? might return :BUS:B1:ARINC429A:BITRATE
HI
, indicating the bit rate is set to handle high speed signals.
BUS:B<x>:ARINC429A:BITRate:CUSTom
This command sets or queries the ARINC429 custom bit rate for the specified
bus. The bus is specified by x.
Conditions
Requires option SR-AERO.
Group
Bus
2-11 4 MSO54, MSO56, MSO58, MSO58LP Programmer