Tektronix MSO58

Commands listed in alphabetical order
SEARCH:SEARCH
1:TRIGger:A:BUS:FLEXRAY:ERRT YPE?
might return
:SEARCH:SEARCH1:TRIGGER:A: BUS:FLEXRAY:ERRTYPE CRCHE ADER,
indicating the error type is CRCHEADER.
SEARCH:SEAR
CH<x>:TRIGger:A:BUS:FLEXray:FRAMEID:HIVALue
This command sets or queries the high value when searching on a FlexRay bus
frame id field. The search condition must be set to IDentifier. The search number
is specifie
dby<x>.
Group
Search and Mark
Syntax
SEARCH:SEARCH<x>:TRIGger:A :BUS:FLEXray:FRAMEID:HIVALue
<QString>
SEARCH:SEARCH<x>:TRIGger:A :BUS:FLEXray:FRAMEID:HIVALue?
Arguments
<QString> is the frame id high value.
Examples
SEARCH:SEARCH1:TRIGger:A:B US:FLEXray:FRAMEID:HIVALue
"XXXXXXX1010"
sets the HIVALUE to XXXXXXX1010.
SEARCH:SEARCH1:TRIGger:A:B US:FLEXray:FRAMEID:HIVALue? might
return
:SEARCH:SEARCH1:TRIGGER:A:B US:FLEXRAY:FRAMEID:HIVALUE
"XXXXXXXXXXX"
indicating the HIVALUE is XXXXXXXXXXX.
SEARCH:SEARCH<x>:TRIGger:A:BUS:FLEXray:FRAMEID:QUALifier
This command sets the qua lifier to be used when searching on a FlexRay bus
signal. The search condition must be set to Identifier. The search number is
specified by <x>.
Group
Search and Mark
Syntax
SEARCH:SEARCH<x>:TRIGger:A :BUS:FLEXray:FRAMEID:
QUALifier {EQual|UNEQual LESSthan|MOREthan|LESSEQu al|
MOREEQual|INrange|OUTrange }
SEARCH:SEARCH<x>:TRIGger:A :BUS:FLEXray:FRAMEID:QUALifier?
Arguments
Argumentsaretheavailabledataqualifiers.
MSO54, MSO56, MSO58, MSO58LP Programmer 2-669