Tektronix MSO58

Commands listed in alphabetical order
Arguments
<QString> is th
e word count value.
Examples
SEARCH:SEARCH1:TRIGGER:A:B US:MIL1553B:COMMAND:SUBADDRESS
"X1000"
sets the value to X1000.
SEARCH:SEARCH1:TRIGGER:A:B US:MIL1553B:COMMAND:SUBADDRESS?
might return "XXXXX", indicating that the value is XXXXX.
SEARCH:SEARCH<x>:TRIGger:A:BUS:MIL1553B:COMMAND:TRBit
This command sets or queries the value of the command word Transmit / Receive
bit for a MIL-STD-1553 bus to search on. The search number is specified by x.
The search condition must be set to COMMAND.
Conditions
Requires the SR-AERO Triggering and Analysis application.
Group
Search and Mark
Syntax
SEARCH:SEARCH<x>:TRIGger:A :BUS:MIL1553B:COMMAND:TRBit
{RX|TX|X}
SEARCH:SEARCH<x>:TRIGger:A :BUS:MIL1553B:COMMAND:TRBit?
Arguments
RX filters command words to only match those that are receive packets.
TX filters command words to only match those that are transmit packets.
X disables filtering of command w ords on the R/T bit.
Examples
SEARCH:SEARCH1:TRIGGER:A:B US:MIL1553B:COMMAND:TRBIT TX
specifies filtering command words for only transmit messages.
SEARCH:SEARCH1:TRIGGER:A:B US:MIL1553B:COMMAND:TRBIT? might
return X, indicating that command words are not being filtered based on the R/T
bit value.
SEARCH:SEARCH<x>:TRIGger:A:BUS:MIL1553B:CONDition
This command sets or queries the field or condition for a MIL-STD-1553 bus to
search on. The search number is specified by x.
Conditions
Requires the SR-AERO Triggering and Analysis application.
MSO54, MSO56, MSO58, MSO58LP Programmer 2-685