Tektronix MSO58 User Manual (English)

To Next Page

To Previous Page

Commands listed in alphabetical order

Examples

MEASUREMENT:F

ILTERS:LOWPASS:SPEC SECOND

speciﬁes a second order low

pass ﬁlter.

MEASUREMENT:FILTERS:LOWPAS S:SPEC? might return

:MEASUREMENT:FILTERS:LOWPA SS:SPEC NONE indicating no low

pass ﬁlter.

MEASUrement:FILTers:RAMPtime

This command sets or queries the global ﬁlter ramp time for the measurement.

Group

Measurement

Syntax

MEASUrement:FILTers:RAMPti me <NR3>

MEASUrement:FILTers:RAMPti me?

Arguments

<NR3> is the c urrent ﬁlter r amp time.

Examples

MEASUREMENT:FILTERS:RAMPTI ME 3.0 sets the ramp time to 3.0.

MEASUREMENT:FILTERS:RAMPTI ME? might return

:MEASUREMENT:FILTERS:RAMPT IME 2.0000 indicating the ramp time is 2.0.

MEASUrement:GATing

This command sets or queries the global gating type for the measurement.

Group

Measurement

Syntax

MEASUrement:GATing {NONE|SCREEN|CUR Sor|LOGic|SEARch }

MEASUrement:GATing?

Arguments

NONE turns off measurement gating.

SCREen turns o n gating, using the left and right edges of the screen.

CURSor limits measurements to the portion of the waveform between the vertical

bar cursors, even if they are off screen.

LOGic speciﬁes that measurements are taken only on the portion of the waveform

wherethelogicsourceisintheactivestate.

SEARCH speciﬁes that measurements are taken based on search crite ria.

MSO54, MSO56, MSO58, MSO58LP Programmer 2-405

Tektronix MSO58 User Manual