Agilent Technologies InfiniiVision 5000 Series Programmer's Guide

538 Agilent InfiniiVision 5000 Series Oscilloscopes Programmer's Guide
6 Commands A-Z
• ":CHANnel<n>:PROBe" on page 199
• ":CHANnel<n>:PROBe:ID" on page 200
• ":CHANnel<n>:PROBe:SKEW" on page 201
• ":CHANnel<n>:PROBe:STYPe" on page 202
• ":CHANnel<n>:PROTection" on page 203
• ":CHANnel<n>:RANGe" on page 204
• ":CHANnel<n>:SCALe" on page 205
• ":CHANnel<n>:UNITs" on page 206
• ":CHANnel<n>:VERNier" on page 207
• CLEar Commands:
• ":DISPlay:CLEar" on page 210
• ":MEASure:CLEar" on page 274
• CLOCk Commands:
• ":TRIGger:IIC[:SOURce]:CLOCk" on page 457
• ":TRIGger:SPI:CLOCk:SLOPe" on page 471
• ":TRIGger:SPI:CLOCk:TIMeout" on page 472
• ":TRIGger:SPI:SOURce:CLOCk" on page 476
• "*CLS (Clear Status)" on page 101
• COMPlete, ":ACQuire:COMPlete" on page 166
• CONDition, ":HWERegister:CONDition (Hardware Event Condition
Register)" on page 136
• CONNect, ":DISPlay:CONNect" on page 572
• COUNt Commands:
• ":ACQuire:COUNt" on page 167
• ":ACQuire:SEGMented:COUNt" on page 172
• ":MTESt:AVERage:COUNt" on page 601
• ":MTESt:COUNt:FWAVeforms" on page 328
• ":MTESt:COUNt:RESet" on page 329
• ":MTESt:COUNt:TIME" on page 330
• ":MTESt:COUNt:WAVeforms" on page 331
• ":SBUS:CAN:COUNt:ERRor" on page 375
• ":SBUS:CAN:COUNt:OVERload" on page 376
• ":SBUS:CAN:COUNt:RESet" on page 377
• ":SBUS:CAN:COUNt:TOTal" on page 378
• ":SBUS:CAN:COUNt:UTILization" on page 379

Agilent Technologies InfiniiVision 5000 Series Specifications

General

Brand	Agilent Technologies
Model	InfiniiVision 5000 Series
Category	Test Equipment
Language	English